vmf-IOC16T 200-565-101-013 200-565-000-013 vibro-meter

The ‌VMF-IOC16T (200-565-101-013 / 200-565-000-013) PCB Circuit Board Operational Steps‌

‌Key Procedures‌

1. ‌Pre-Installation Checks‌

   • Verify ‌P/N labels‌ match (200-565-101-013 for standard I/O, 200-565-000-013 for redundant configurations).
   • Inspect PCB for physical damage (e.g., cracked traces or burnt components).

2. ‌Power & Grounding‌

   • Connect ‌24V DC ±5%‌ to terminals PS+/PS- (redundant power inputs if applicable).
   • Ensure chassis ground resistance ≤0.1Ω via dedicated grounding screw.

3. ‌I/O Wiring‌

   • ‌Analog Inputs (AI1-AI8)‌: Use shielded twisted pairs (e.g., Belden 8761) for 4-20mA/1-5V signals.
   • ‌Digital Outputs (DO1-DO4)‌: Max load 2A @ 30V DC per channel.
   • ‌Isolation‌: Maintain 500V isolation between channels (CAT II).

4. ‌Configuration‌

   • Dip-switch settings (SW1-SW4):
     • ‌SW1.1 ON‌: Enable Modbus RTU (address set via SW2-SW4 binary coding).
     • ‌SW1.2 ON‌: Activate fail-safe mode for DOs.
   • Calibrate AI channels via ‌VM600 QuickCal‌ software (offset ±0.1% FS adjustable).

5. ‌Diagnostics‌

   • ‌LED Indicators‌:
     • ‌Green (PWR)‌: Power OK
     • ‌Red (ERR)‌: Fault (check VM600 event log)
   • Measure test points (TP1-TP3) with multimeter:
     • TP1: +5V ref (±0.5%)
     • TP2: Ground integrity (≤10mV noise)

vmf-IOC16T 200-565-101-013 200-565-000-013 PDF
vmf-IOC16T 200-565-101-013 200-565-000-013‌

···········································································································

Our advantages:

1. The brand new product comes with a one-year

comprehensive warranty.

2. All products undergo strict quality inspections.

3. Contact us and our team will provide competitive

quotes and procurement plans.